You should see a rod connecting the handle to the door lock assembly.
Audi door handle sensor not working.
When one sensor fails the entire system shuts off.
I had to clear the door sensor odb code before it recognized that it was replaced.
If it is okay check the cable that runs from the handle to the actuator.
It will tell you exactly why the keyless entry system isn t working.
Why is the outside door handle on a 2008 audi tt intermittently not working.
Push down the clip to loosen the rod then pull the rod up and out of the door.
There is a plastic clip attached to this rod.
Check the actuator and replace if found to be faulty.
Are you having problems with your door locks either from the key fob or the inside handles.
They are notorious for going bad.
If the actuator was not replaced along with the handle this may be the cause.
Unbolt the door lock assembly from the door and then pull the assembly out.
Each door has a sensor in the handle.
For the sensor your part number is probably 4g8927753b.
On this occassion all door handles and boot sensors work when unlocking the car and all locking sensors work except on on drivers door.
Takes a little patience to remove the door handle as well as remove the sensor part from the handle.