A Way To Separate Backing From Vinyl

Of course when trying to film it doesn t work out so quickly lol.

A way to separate backing from vinyl.

The easiest way to separate the film from the liner is with two pieces of scotch tape as pictured. I have stickers that i could not separate and when i did the paper its self separated not the sticky part. Make sure your project surface is clean dry. Use a scraper and a chisel to loosen large gobs of glue.

How to properly remove transfer tape from a decal when the vinyl is sticking to the backing paper. Place the film against the set up paned with the adhesive liner side facing you. After you master this it only takes about 5 seconds. How to separate the liner from the film.

If the vinyl does not separate from the liner simply burnish the transfer tape onto the vinyl and peel away again. Carefully place the transfer tape with vinyl images onto your surface as you would like them to appear. Heat the remaining backing with a heat gun. I searched for a video that showed h.

It must be removed prior to application. If you are frustrated with not being able to remove the backing from stickers and labels then here is a tip that shows you how to do it quickly and easily. Peel away the vinyl liner at a 45 degree angle. Since the vinyl is gone and only the backing remains it won t take much heat to soften the backing and underlying glues.

Pull up the strips one at a time. This short video shows how to easily remove the backing sheet from label paper. With less tacky clear transfer tapes and or other conditio. We just knew there had to be an easier way.

Cut the vinyl flooring into strips using a utility knife.